Ball mill head
The inlet and outlet end cover of the ball mill is one of the main components of the ball mill. It is installed at both ends of the mill cylinder and supported on the bearing.
The inlet and outlet end cover of the ball mill is one of the main components
of the ball mill. It is installed at both ends of the mill cylinder and
supported on the bearing. It is mainly used to support, seal and fix the mill
body. It can not only ensure the normal operation of the ball mill, but also
effectively improve the service life of the ball mill. The rounded corner of the
end disc root of the hollow shaft of the ball mill is the place where the stress
is concentrated.
Related products
-
Ballast Core
Contact UsJiangyin Tianxiang Electrical Appliance Co., Ltd. was established in 1990. The company currently covers an area of more than 35,000 square meters and a building area of 18,000 square meters.
-
Strong NdFeB magnet for permanent magnet motor, arc shape
Contact UsMostly used in the permanent magnet motor
-
Oblique Cut Lamination
Contact UsShearing is a common cutting method for silicon steel sheets. Silicon steel is sheared with a carbide blade, which can cut the required size and shape. Shear method on the thermal impact of silicon steel core is small, the kerf is smoother, but the shear force is more damage, easy to produce deformation and burr. Therefore, the shear method is suitable for cutting smaller lamination, the requirement of surface flatness is not too high occasions.
Our company has introduced advanced oblique cut equipment, which is able to cut large silicon steel core to meet more needs of customers. -
QUINCY CONNECTOR VIBRA-LOK 142299 1/4 NPT
Contact UsWe are QUINCY CONNECTOR VIBRA-LOK 142299 1/4 NPT supplier and provide replacement parts for major air compressor manufacturers.
Reviews
There are no reviews yet.