Gel sealed Mini-pleat HEPA filter（top gel seals）
The two-component gel is poured into the liquid seal type HEPA filter , and this is used as an installation seal.
The two-component gel is poured into the liquid seal type HEPA filter , and
this is used as an installation seal. This seal form has high reliability and is
suitable for PAO dust detection on site. Mainly used in the end of 0.3μm clean
room and purification equipment in the pharmaceutical industry to control
particles and microorganisms larger than 0.3μm in the clean room or equipment
work area. There are two types of HEPA filter, side sealing and top sealing.
|
Frame |
Aluminum |
|
Spacers |
EVA |
|
Filter media |
Glass fiber |
|
Gasket |
Gel |
|
Operation conditions |
<80%/100%RH.40℃ |
|
Model |
Specification(W×H×D) |
Rated air volume(m3/h) |
Initial resistance(Pa) |
Weighting efficiency（PA） |
Effectiveness@MPPS |
|
CYWGB410.410-93H14 |
410×410×93 |
500 |
220 |
450 |
99.995%≤E<99.9995% |
|
CYWGB550.550-93H14 |
550×550×93 |
1000 |
|||
|
CYWGB650.650-93H14 |
650×650×93 |
1500 |
|||
|
CYWGB750.750-93H14 |
750×750×93 |
2000 |
Related products
-
TNV direct fired incinerator
Contact UsDesign and manufacture by using the German EN12753 safety standard and the European ED. It is used Metal Painting and Printing LED Drying:
1. For stable industrial and mining conditions with a high temperature concentration of 1.5g/M3 or above.
2. Industrial and mining conditions with requirements for thermal energy recovery and utilization.
3. Industrial and mining conditions required for the operation of independent drying rooms.
4. Special effects on projects that reduce emissions and increase production -
NGB High Temperature-resistant 350℃ Separator HEPA Filter
Contact UsThe filter material is high temperature resistant ultra-fine glass fiber filter paper, and the separator is aluminum foil corrugated sheet.
-
Kssc-zh061k Wet Grinding Dust Collector
Contact UsIt is main applied to flammable, explosive and big spark metal dust.
The air with dust entries into dust collector through suction inlet section under the fan working status, the bigparticles will drop into water tank bottom. -
Annual output of 120,000 tons of DMF, 20,000 tons of NMF project – waste liquid and waste gas incineration treatment system
Contact UsThis project plans to build a set of waste liquid and waste gas direct-fired incinerator. Including but not limited to construction drawing design, waste gas feeding system, waste liquid feeding system, combustion assistance and feeding system, incineration system, waste heat recovery system, denitration system, smoke exhaust system, auxiliary system, electronic control instrument system, etc.
Reviews
There are no reviews yet.